How to make a kitchen cabinet yourself

Before you start making a closet with your own hands, you need to make measurements where you will install the cabinet, make measurements of each cabinet that will hang on the wall and install on the floor. Measurements need to be made very carefully, so that then when installing everything goes as it should. It is very important - you need to measure in millimeters in order to obtain the necessary gaps for the density of fitting all the details of the cabinets. Then, based on the size of the cabinets, draw a sketch. You can draw a drawing yourself, the main thing is that you understand how to do it. To create a cabinet, you need special sizes with the required number of components. Make a sketch taking into account all the measurements of the cabinets and the installation site. On paper, draw a scheme of image of cabinets with all measurements, width and length. And next to him, write down all the details from the cabinet that will be attached to each other. How to make a kitchen cabinet with your own hands. Useful advice to another sheet Write down all materials (handles, screws, accessories, awnings) that will be needed to build a cabinet and measurements, in case you lose the first sheet of paper. This is all necessary to add the amount necessary to buy all the material. And in order not to forget what materials you need to buy. The calculated amount can be compared with the fact that it is cheaper to do everything with your own hands, give work to a specialist or just buy in a store. For your list we buy all the necessary materials. If there was not enough funds, it will be possible to take the same detail, but cheaper. First you need to buy material for equipment, and then for finishing. The chipboard is marking all materials and parts, 2 mm allowance should remain on each part. On each side to create lumps. All measurements are made only with a simple pencil. If the details, write from the inside. And if shelves, from the bottom. Never write a helium pen or simple pen. After applying the paint, everything that you wrote will not be painted and will be visible. The part will have to be replaced. Debred parts of the edges must be strict, according to the marked measurements. Immediately note where there will be a handle at the door where the glass will be inserted. There should be two self -tapping screws in the shelf. We connect the details of the kitchen cabinet with screws, first collect and see how your closet will look. Only when you collect the work completely, you can understand what did wrong. As a result of pre -viewing, we fasten all the details with small screws. After you saw your mistakes, disassemble the cabinet, eliminate all the inaccuracies and errors. And then collect again. And your piece of furniture is completely ready. Play and bet at https://greenchar.co.ke/ online.